GICD_CPENDSGIR<n> SGI Clear-Pending Registers 0 3 GIC Distributor Dist_base 0x0F10 + (4 * n) GICD_CPENDSGIR<n> RW Removes the pending state from an SGI. A write to this register changes the state of a pending SGI to inactive, and the state of an active and pending SGI to active. GICD Four SGI clear-pending registers are implemented. Each register contains eight clear-pending bits for each of four SGIs, for a total of 16 possible SGIs. In multiprocessor implementations, each PE has a copy of these registers. GICD_CPENDSGIR<n> is a 32-bit register. SGI_clear_pending_bits<x> 31 0 31:0 Removes the pending state from SGI number 4n + x for the PE corresponding to the bit number written to. Reads and writes have the following behavior: 3 0 0x00 If read, indicates that the SGI from the corresponding PE is not pending and is not active and pending. If written, has no effect. 0x01 If read, indicates that the SGI from the corresponding PE is pending or is active and pending. If written, removes the pending state from the SGI for the corresponding PE. 0x00000000 For SGI ID m, generated by processing element C writing to the corresponding GICD_SGIR field, where DIV and MOD are the integer division and modulo operations: The corresponding GICD_CPENDSGIR<n> number is given by n = m DIV 4. The offset of the required register is (0xF10 + (4n)). The offset of the required field within the register GICD_CPENDSGIR<n> is given by m MOD 4. The required bit in the 8-bit SGI clear-pending field m is bit C. These registers are used only when affinity routing is not enabled. When affinity routing is enabled, this register is RES0. An implementation is permitted to make the register RAZ/WI in this case. A register bit that corresponds to an unimplemented SGI is RAZ/WI. These registers are byte-accessible. If the GIC implementation supports two Security states: A register bit that corresponds to a Group 0 interrupt is RAZ/WI to Non-secure accesses. Register bits corresponding to unimplemented PEs are RAZ/WI. 2026-03-26 20:27:25 2026-03_rel