TRCEVENTCTL1R Trace Event Control 1 Register when FEAT_ETE is implemented and FEAT_TRC_EXT is implemented ETE 0x024 TRCEVENTCTL1R When OSLockStatus(), or !AllowExternalTraceAccess(addrdesc), or !IsTraceCorePowered() ERROR RW TRCEVENTCTL1R Architectural AArch64 31 0 31 0 31 0 31 0 Controls the behavior of the ETEEvents that TRCEVENTCTL0R selects. Trace TRCEVENTCTL1R is a 32-bit register. 31 14 31:14 Reserved, RES0. OE 13 13 0 ETE Trace Output Enable control. 0b0 Trace output to any IMPLEMENTATION DEFINED trace output interface is disabled. 0b1 Trace output to any IMPLEMENTATION DEFINED trace output interface is enabled. '0' When TRCIDR5.OE == '1' 13 13 13 Reserved, RES0. Otherwise LPOVERRIDE 12 12 0 Low-power Override Mode select. 0b0 Trace unit Low-power Override Mode is not enabled. That is, the trace unit is permitted to enter low-power state. 0b1 Trace unit Low-power Override Mode is enabled. That is, entry to a low-power state does not affect the trace unit resources or trace generation. When TRCIDR5.LPOVERRIDE == '1' 12 12 12 Reserved, RES0. Otherwise ATB 11 11 0 AMBA Trace Bus (ATB) trigger enable. If a CoreSight ATB interface is implemented then when ETEEvent 0 occurs the trace unit sets: ATID == 0x7D. ATDATA to the value of TRCTRACEIDR. If the width of ATDATA is greater than the width of TRCTRACEIDR.TRACEID then the trace unit zeros the upper ATDATA bits. If ETEEvent 0 is programmed to occur based on program execution, such as an Address Comparator, the ATB trigger might not be inserted into the ATB stream at the same time as any trace generated by that program execution is output by the trace unit. Typically, the generated trace might be buffered in a trace unit which means that the ATB trigger would be output before the associated trace is output. If ETEEvent 0 is asserted multiple times in close succession, the trace unit is required to generate an ATB trigger for the first assertion, but might ignore one or more of the subsequent assertions. Arm recommends that the window in which ETEEvent 0 is ignored is limited only by the time taken to output an ATB trigger. 0b0 ATB trigger is disabled. 0b1 ATB trigger is enabled. When TRCIDR5.ATBTRIG == '1' 11 11 11 Reserved, RES0. Otherwise 10 4 10:4 Reserved, RES0. INSTEN[<m>] 3 0 3:0 Event element control. 3 0 0b0 The trace unit does not generate an Event element <m>. 0b1 The trace unit generates an Event element <m> when ETEEvent <m> occurs. When TRCIDR4.NUMRSPAIR == '0000' RES0 TRCIDR4.NUMRSPAIR != '0000' m > UInt(TRCIDR0.NUMEVENT) RES0 RW Must be programmed. Writes are CONSTRAINED UNPREDICTABLE if the trace unit is not in the Idle state. 2026-03-26 20:27:25 2026-03_rel